Posts Tagged ‘solar panels’

UAV/UAS Drones are often victim to Radio Frequency Interference (RFI), especially when being used anywhere near metal or other energized objects such as electric fences, radio towers and antennas, power lines and switch yards, and other RC Signals.  It’s just a fact that pilots have to consider and deal with when planning and executing a plight plan.

Obstructions like buildings, especially ones with lots of metal, WiFi systems and the miles of energized cabling that the building is hosting.

Pilots also have to consider their restricted Flight Path, due to Radio Range limitations.  Pilots cannot just plan a long shot down a highway without hitting the “Radio Fence” at some point.  Once the UA has lost their connection with the pilot, it’s programmed (or should be) to shut down the radio and use it’s own on-board system to return to it’s launch-site.

Imagine if you could reduce the chances of these issues to a near zero factor.

You can be confident that your radio signal is powerful and present to a degree that minimizes the chances of RFI is not a concern; You won’t have to worry about a superstructure or office-building will create a Radio Frequency “Shadow”, knowing that you will have seamless control in and around your flight path; You can plan flights that can literally extend over the hill and through the woods, all the way to grandma’s house, or as far as your battery will let take your UAV.

UAV Repeater System

By using this Unmanned Aircraft Repeater System (UARS), comprised of a system of Connected and Controlled Wireless Access Points (WAPs), you can setup a customized Radio Perimeter to establish an RF Secure Flight. The modular design allows the repeaters to be setup almost anywhere in seconds.  With Low-Power Consumption Electronics, the UARS is powered by a Rechargeable Battery System that includes a Solar Charging System to charge the battery when not in use, and to greatly extend the UARS “On-Air” Time while in use.  The Network is secured and controlled using the Small and Energy Efficient Raspberry Pi ARM Based Computer System.  The system is also designed to be directly powered and charged with any standard AC source.

UAV Repeater System Parts

The entire package comes with a customized water-tight package that is designed to mount to almost any tripod, and is Tamper and Theft Resistant.  Using basic locking and theft-deterrent systems to secure the UARS and it’s payload of gear, you won’t have to worry about it growing legs or being plundered in mid-production.  The system is programmed to alert you of any GPS changes, excessive vibration or movement, and can include the optional PTZ Camera (not shown) that allows you to view or monitor the area around the UARS with simple Video Surveillance Software and a Laptop, exactly like the remote police observation towers. The UARS standalone tower has a very long operational “On-Air” run time of over 120 minutes.

The system also comes in a Waterproof Floating Configuration (UARS-F) for over-water flights.  The UARS-F (not shown) has a large 4 foot square Solar Landing Area with a net system extending 12″ over the edge to be used as an emergency Landing Zone (LZ).  It is fully-motorized and uses the same GPS Location System that UAVs are tied to.  The “Buoy-Mode”, the UARS-F can maintain it’s nautical position, giving your flight-plan a major advantage and a safe alternate LZ in the case you need to land over-water.  In “Extend-Mode”, the UARS-F will attempt to maintain a centralized position between the pilot and UAV.  In “Follow-Mode”, the UARS-F will attempt to maintain a programmed position as it relates to the location of the UAV or Pilot; if the UAV or Pilot moves 10 meters south, the UARS-F will move 10 meters south.  Depending on how the UARS-F is used and its operating conditions, it has an average “On-Air” run time of 120 minutes with light-currents, and over 5 hours on still-water.  The UARS-F is not designed to operate on water with strong currents.

The UARS-A (Ariel) model is a complete UARS Drone (not shown).  It’s waterproof design and Solar Shell keeps it protected from rain or slashes and powered with extra flight juice from the sun.  The UARS-A operates with the same GPS Location Controller that the UARS-F is equipped with, allowing you to program its behavior or flight-paths.  The on-board Obstacle Avoidance Radar will keep it safely distanced from or between objects that might otherwise interrupt its flight.  Because of the Solar-Shell, the UARS-A has an average flight time of 30 minutes in sunny conditions.

.What do you think?

Read Full Post »

After being accepted into the NJATC Apprenticeship Program in March 2012, I became a member of the IBEW.

Since then, I have installed Solar panels with Pheonix Solar; assisted with electrical installations at the Nissan Leaf Paint Shop 4 facility; laid groundwork piping for the new HCA Data Center in Nashville with BESCO; working with Conti Electric on various projects and punchlists in the construction of the new Nashville Music City Center; assisted with the installation and upgrading of the Hill-Rom Patient Call Systems at the Downtown Nashville VA Hospital with BESCO, and assisting with the lighting demolition and installations at Hoaganese, a manufacturing plant that produces customized precision formulas of powdered steel to be made into anything from welding rods to transmission parts.


Read Full Post »